402 Chapter 5
Command Definitions L-O
OCTCOMP
OCTCOMP
Converts a compiled MPE V/E program into native mode (NM) code for the HP 3000 Series
900. (Native Mode)
CAUTION Before using this command be sure your logon group and account does not
contain files of the form Yn, Ynn or Ynnn where n is any alphanumeric
character. OCTCO
MP may create temporary files named in this format and similarly named
permane nt files may cause an error condition.
Syntax
OCTCOMP[ input][,[targetfile][,[list] ] [ ;INFO=quotedstring] ] or OCTCOMP [ input]
[,[targetfile][,[list] [ ,[ INFO=] quotedstring]]] *
* Refer to the help option of the INFO=quotedstring
NOTE This command follows the optional MPE/iX command line syntax. Refer to
"Optional Format for MPE/iX Commands" at the beginning of this chapter.
Parameters
<omitted> If no parameters are specified OCTCOMP returns a command usage
message and then exits.
input Name of the valid input program or SL file to be translated. A valid
program is a CM PROG or SL file that can be loaded by the CM loader.
targetfile Name of the file to hold the translated output. (Refer to "Operation Notes"
for a description of the default for this parameter.) If targetfile does not
exist, it is created. If it already exists, it is purged and a new file is created.
list Name of the file to which object code translator writes listing and error
messages. If you omit this parameter, the messages are sent to $STDLIST.
All parameter parsing errors are written to $STDLIST.
INFO= quotedstring A list of parameters to define format and content of translated output.
This parameter list must be surrounded with double or single quotation
marks („ or '), and each parameter set in the list must be delimited with a
semicolon if more than one set is given in command string.
help Print detailed description of OCTCOMP parameters. This is
the only option that does not require a source.
OCTCOMP;INFO=„HELP„ is valid; so is OCTCOMP
,,,„HELP„.
