A SERVICE OF

logo

Removal and replacement procedures 38
7. Perform the post-installation procedure.
Optical disc drive
The following SATA ODD models are supported:
DVD drive
DVD-RW drive
To install an optical disc drive:
1. Using the HP ProLiant MicroServer key to unlock the panel door.
2. Open the panel door of the server. If necessary, remove any components or cables that prevent
access to the slot.
3. Loosen the rear thumbscrew which locks the panel on the chassis.
4. Slide the top panel forward, and then lift to remove it from the chassis.
5. Remove the plastic faceplate from the top panel. Store it for future use.