Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
Operating Notes:
■ The following information is displayed for each installed transceiver:
• Port number on which transceiver is installed.
• Type of transceiver.
• Product number—Includes revision letter, such as A, B, or C. If no
revision letter follows a product number, this means that no revision
is available for the transceiver.
• Part number—Allows you to determine the manufacturer for a spec-
ified transceiver and revision number.
■ For a non-ProCurve installed transceiver (see line 23 Figure 10-8), no
transceiver type, product number, or part information is displayed. In the
Serial Number field, non-operational is displayed instead of a serial num-
ber.
■ The following error messages may be displayed for a non-operational
transceiver:
• Unsupported Transceiver. (SelfTest Err#060)
Check: www.hp.com/rnd/device_help/2_inform for
more info.
• This switch only supports revision B and above
transceivers. Check: www.hp.com/rnd/device_help/
2_inform for more info.
• Self test failure.
• Transceiver type not supported in this port.
• Transceiver type not supported in this software
version.
• Not a ProCurve Transceiver. Please go to:
www.hp.com/rnd/device_help/2_inform for more info.
Enabling or Disabling Ports and Configuring Port Mode
You can configure one or more of the following port parameters. Refer to table
10-1 on pages 10-4 through 10-5.
Syntax: [no] interface < port-list >
[< disable | enable >]
Disables or enables the port for network traffic. Does not
use the no form of the command. (Default: enable.)
10-15
