44
Jack PC Hardware User Manual - Training Department
Version 0506
9 REGULATORY COMPLIANCE
This product has been tested and found to comply with the limits of the regulations needed to
receive the following marks:
• EMI/EMC: FCC Class B; CE Mark; VCCI.
• Electrical Safety: UL60950-1; cUL Listing; CE Mark (IEC/EN 60950).
• This product is ENERGY STAR labeled and meets the ENERGY STAR guidelines for
energy efficiency.
9.1 Jack-PC Requirements Compliance
• FCC Compliance - The Jack PC meets Class B requirements.
• IEC/EN Compliance - The Jack PC meets Class B requirements.
9.2 FCC Statements
FCC Part 15 – Class B
This product has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This product generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that the interference will not occur in a particular installation. If this product does
cause harmful interference to radio or television reception, which can be determined by turning the
product OFF and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the product and receiver.
• Connect the product into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced Radio/TV technician for help.
9.3 IEC/EN Notice
This product conforms to requirements of EN55022 for Class B product.
9.4 Modifications
The Jack PC is especially designed for many years of continuous operation. No maintenance
or upgrade is possible for this product except for normal software configuration and loading
that do not require opening of the product’s external enclosure.
Never open the product’s enclosure and never attempt to replace any internal part. Doing so
might damage the product and will terminate the product warranty immediately.
9.5 Cables
Connections to this device must be made with shielded cables with metallic RFI/EMI
connector hoods in order to maintain compliance with FCC Rules and Regulations.
9.6 Peripheral Devices
Only peripherals (input/output devices, printers, etc.) certified to comply with the Class B limits
might be attached to this product. Operation with non-certified peripherals is likely to result in
interference to radio and TV reception.
