A SERVICE OF

logo

Bosch Supplier Logistics Manual, Release. 3.0
Robert Bosch GmbH, CP/LOG, 07.05.2007 Page 23(35)
Available label pockets must be used.
Tags must be attached to returnable packaging by means of easily removable, residue-free adhesive
spots or adhesive tape. Tags must not be glued onto returnable packaging.
In the case of deliveries in "KLT" small load carriers on pallets the top layer must form a single, even
plane.
The undamaged condition of pallets and box pallets (e.g. in accordance with the exchange criteria of
the European Pallet Association EPAL
(Internet: http://www.epal-pallets.org )) and other containers
must be ensured.
The packaging must be clean. Compliance with BOSCH-specific cleanliness regulations and
conditions in the delivery and production areas must be ensured.
Special requirements apply to electrostatic sensitive devices.
Compliance with VDE, DIN and BOSCH standards where applicable must be ensured.
Mixed consignments are permitted in principle, unless otherwise agreed. The number of mixed
consignments should be kept to a minimum. Identical items should be distributed across the smallest
possible number of shipping units.
3.3 Labeling of Shipping Units
3.3.1 Labeling Methods
All shipping units are to be identified by a master label. The following minimum data are required:
- BOSCH type/ BOSCH part number
- Total quantity
- Name of SUPPLIER/ SUPPLIER number
In the case of heterogeneous shipping units (mixed containers) it must be ensured by SUPPLIER that:
- the transport packaging is identified as a "mixed shipment"
- all BOSCH part numbers in the container are identified with their respective total quantities and
- different releases within the shipping unit are physically separated from each other and clearly
identified.
The smallest packing units generally should be marked by a barcode. The introduction of barcodes
must be agreed with the receiving BOSCH plant concerned. All barcodes must correspond to code 39.
- Label information:
- BOSCH type/ BOSCH part number