-
Using the o\€n for storage
purposes:
-
Using
flammable liquids near the appliance;
-
Using
adaptors, multiple sockets and/or
erdension cords;
-
Aftempting to install or repair the appliance
without the
assistance of
qualified personnel.
Qualified
p€rsonnel
must be contacted
in the following
cases:
-
Installation
(bllo|ing
the manuhcture/s
instructions);
-
When in doubt about operating the appliance;
-
Replacing the electrical outlet
when it is not compatible
with the
plug
br the applianc€.
Servic€ Centres authorized
by the manufacturer must
b€ contacted in the Sollowing cases:
-
lf in doubt about
the soundness of the aooliance after
removing it ftom the
packaging;
-
lf the
po,ver
supply cord
has been damaged or needs to
be
replaced:
-
lf the appliance breaks down or functions
poorly;
ask br
original spare
parts.
lnstallation
lmportant:
The
power
supply lo the appliance
must
be
cut off before any
adjustments or mainlenance work
is
done on
it.
lnstallation of Built-in Ov6ns
In
order
to insure that the built-in apDliance
functions
properly,
the cabinet containing it must be appropriate.
The
figure
belo/v
gives
the dimensions of the cutout frcr
installation under the counter or in a cabinet wall unit.
It
is a
good
idea to do ths
following:
Only use
the
appliance
to cook food, nothing
else;
Check
the soundness of the aDoliance
afier it has been
unoacKeo:
disconnecl the appliance
from the electrical
mains if it is
not funciioning
properly
and before deaning or
performing
maintenance;
When the appliance
is not used
tor
an
extended
period
of time, cut off
the supply of
power
and close
the
gas
cock
(if present);
Use cooking
gloves
to
place
@okware
in the oven or
when removing it;
Always
grasp
the oven door
in the centre because the
ends
may
be
hot due to the escape of
hot air;
Make sure that the control
knobs are on the
"'"fo"
setting
when the appliance
is not in use;
Cut the
power
supply chord
afler disconnecting
it from
the mains when
you
decide
not to use the appliance any
|onger.
The man uhctu
rer will not be held liable br any
damages
that
might arise out of inconect
installation or improper,
inmnect or unreasonaue use
of the aoDliance.
In order to ensure adequate venlilation, the back
panel
of
the cabinet must be
removed. Installing the oven so that it
rests on tu/o strips of
wood is
prebrable.
In the case where
the oven rests on a continuous,
flat surface, there must
be an aperture of at
least 45 x 560 mm.
