Multifunctional settings
OPTION Menu
turns on/off the automatic keystone
You can automatically correct vertical keystone distortion
corresponding to the angle (forward/backward tilt) at which the unit
If the projection screen is inclined, or if the projector is angled
downwards, it may not be possible to make the correct adjustment
when V: INVERT or H&V: INVERT is selected under the MIRROR
When the zoom adjustment is set to the TELE side, automatic
correction may be excessive. The automatic correction function
should be used with zoom set to WIDE whenever possible.
This function works with INPUT, RGB, and VIDEO buttons.
When the TURN ON is selected, detecting no signal automatically
cycles through input ports
started from the current port.
when an input is found, the
projector will stop searching and display the image
Using the buttons ▲/▼ adjusts the
automatically turn the projector off
Short (min. 0 minute = DISABLE)
When the time is set to 0, the projector is not turned off automatically.
When the time is set to 1 to 99, and when the passed time with
a no-signal or an unsuitable signal reaches at the set time, the
projector lamp will go off and the power indicator begins blinking.
Please refer to the section
With the OPTION menu, items shown in the table below
Select an item using the cursor buttons ▲/▼ on the
and press the cursor button ►
on the projector or remote control, or the ENTER button on
the remote control to progress
, except for the items LAMP
hen perform it referring to the
MENU [RGB]
VIDEO Qlty.
SETUP
PICTURE
INPUT
OPTION
EASY MENU
SCREEN
:SELECT
AUTO OFF 0
LAMP TIME 0
FILTER TIME 0
ONETOUCH
AUTO SEARCH TURN OFF
IMAGE
NETWORK
SERVICE
