2-8
C
HAPTER
2: D
UAL
T1/PRI C
ONFIGURATION
Where:
BCT
= blocked call type (A for analog calls, N for none, D for
digital, B for both analog and digital.)
DS0#
= DS0 number, 1–23 (24 is reserved as the D-channel)
The blocked call-type column has two subheadings: configured and
current.
As changes are made to this screen, the configured and current column
are updated to reflect the new configuration.
If DS0 call-type blocking commands were issued to the T1/PRI through
Total Control Manager software or some other MIB browser, the current
column displays the call-type being blocked by the command.
Menu Option 14 Configuring the DS0 level service state
This option allows you to remove or restore a DS0 from/to service.
The ability to selectively route calls on specific B-channels are useful for
debugging.
Use the following syntax when configuring this option:
DSS: DS0#
(for single DS0)
DSS: DS0#, DS0#, DS0#-DS0#,...
(for multiple DS0s)
Where:
DSS
= DS0 service state (I for In-Service, O for Out-of-Service)
DS0#
= DS0 number, 1–23 (24 is reserved as the D-channel)
Menu Option 15 Configuring the Short Haul NIC line length
If you are using a Short Haul NIC in conjunction with the T1/PRI card, it
provides a more reliable signal over shorter span line distances. The NIC
provides a DSX-1 interface bypassing the need for a CSU.
