CLI Commands B-35
show atm status Displays current statistics for the ATM protocol running over the ADSL WAN
interface. It lists:
Cell Delineation - Whether or not cell delineation is currently achieved.
ILMI VPI - ILMI Path Identifier used for obtaining dynamic VC’s (Not
supported OfficeConnect Remote 812 1.0).
ILMI VCI - ILMI Channel Identifier used for obtaining dynamic VC’s (Not
supported OfficeConnect Remote 812 1.0).
TX Cells - Number of ATM data cells sent over the WAN.
TX Idle Cells - Number of ATM idle cells sent over the WAN.
RX Good Cells - Number of well-formed and correctly addressed ATM data
cells received from the WAN.
RX Idle Cells - Number of well-formed and correctly addressed ATM idle
cells received from the WAN.
RX No Pkt Avail - Number of times a packet was reassembled but could
not be delivered over the LAN because of lack of packet memory within the
OfficeConnect Remote 812.
RX Bad VPI or VCI - Number of ATM cells received with a bad or inactive
VPI and/or VCI number.
RX Bad HEC - Number of ATM cells received with a bad ATM header.
RX Queue Full - Number of times a packet was dropped because the RX
queue was full.
show adsl statistics Ststaistics for both near end and far end ADSL/ATM link. Counters include
corrected frames, CRC errors, and HEC errors for the Fast and Interleaved path.
show adsl performance Fields:
Number of link down events
Total time since system reboot (hours, minutes, seconds)
Total time since last linkdown:
Errored seconds since last link down:
Total errored seconds in 15 minutes:
Total errored seconds in previous 15 minutes:
show adsl
transceiver_status
Displays the current status of the ADSL/ATM link.
Fields:
Operational Mode: either “loss of signal” or “operational”.
Attenuation Upstream
Attenuation Downstream
Noise Margin Upstream
Noise Margin Downstream
Transmit Power (ATUR)
Transmit Power (ATUC)
