Filter
Top Products
13
English
INTRODUCTION
PREPARATION
BASIC OPERA-
TION
ADVANCED
OPERATION
ADDITIONAL
INFORMATION
APPENDIX
SPEAKER SETUP
AC OUTLETS
4ΩMIN. /SPEAKER
4ΩMIN. /SPEAKER
4ΩMIN. /SPEAKER
4ΩMIN. /SPEAKER
8ΩMIN. /SPEAKER
8ΩMIN. /SPEAKER
8ΩMIN. /SPEAKER
8ΩMIN. /SPEAKER
8ΩMIN. /SPEAKER
SET BEFORE POWER ON
REAR :
REAR CENTER :
CENTER
:
MAIN A OR B
:
A B :
REAR :
REAR CENTER :
CENTER
:
MAIN A OR B
:
+
IMPEDANCE SELECTOR
SET BEFORE POWER ON
REAR :
REAR CENTER :
CENTER
:
MAIN A OR B
:
A B :
REAR :
REAR CENTER :
CENTER
:
MAIN A OR B
:
+
4ΩMIN. /SPEAKER
4ΩMIN. /SPEAKER
4ΩMIN. /SPEAKER
4ΩMIN. /SPEAKER
8ΩMIN. /SPEAKER
8ΩMIN. /SPEAKER
8ΩMIN. /SPEAKER
8ΩMIN. /SPEAKER
8ΩMIN. /SPEAKER
IMPEDANCE SELECTOR
SWITCHED
100W MAX. TOTAL
Switch
position
Upper
Lower
Speaker
Main
Center
Rear
Center
Rear
Main
Center
Rear
Center
Rear
Impedance level
If you use one set of main speakers, the impedance of
each speaker must be 4 Ω or higher.
If you use two sets of main speakers, the impedance of
each speaker must be 8 Ω or higher.
The impedance must be 4 Ω or higher.
The impedance must be 4 Ω or higher.
The impedance of each speaker must be 4 Ω or higher.
If you use one set of main speakers, the impedance of
each speaker must be 8 Ω or higher.
The impedance must be 8 Ω or higher.
The impedance must be 8 Ω or higher.
The impedance of each speaker must be 8 Ω or higher.
IMPEDANCE
SELECTOR
switch
(U.S.A. model)
■ IMPEDANCE SELECTOR switch
WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power of this unit is on, otherwise this unit
may be damaged.
If this unit fails to turn on when STANDBY/ON (or SYSTEM POWER) is pressed, the IMPEDANCE SELECTOR
switch may not be fully slid to either position. If so, slide the switch to either position fully when this unit is in the
standby mode.
Select the left and right position according to the impedance of the speakers in your system. Be sure to move this switch
only when this unit is in the standby mode.