Filter
Top Products
13
1 Recall the preset station on E1 (by following the method
of “To recall a preset station” on page 11).
2
3 Next, recall the preset
station on A5 by following
the same method with step 1.
4
Shows the exchange of stations is completed.
Flashes
Flashes
EDIT
MEMORY
PRESET
MEMORY
PRESET
EXCHANGING PRESET STATIONS
You can exchange the places of two preset stations with each other as shown below.
Example)
If you want to shift the preset station on E1 to A5, and vice versa.
2, 4
EDIT
NOTES ABOUT THE REMOTE CONTROL TRANSMITTER
Battery installation
Battery replacement
If you find that the remote control transmitter must be used
closer to the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
●
Use only AA, R6, UM-3 batteries for replacement.
●
Be sure the polarities are correct. (See the illustration inside
the battery compartment.)
●
Remove the batteries if the remote control transmitter will
not be used for an extended period of time.
●
If batteries leak, dispose of them immediately. Avoid
touching the leaked material or letting it come in contact with
clothing, etc. Clean the battery compartment thoroughly
before installing new batteries.
Remote control transmitter operation range
Notes
●
There should be no large obstacles between the remote
control transmitter and the main unit.
●
If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type of fluorescent lamp etc.),
it might cause the remote control transmitter not to work
correctly. In this case, reposition the main unit to avoid direct
lighting.
2
3
1
30°
30°
Remote control
sensor
Within approximately
6 m (19.7 feet)
REMOTE CONTROL TRANSMITTER