Yamaha HTR-5450 Stereo System User Manual


 
33
English
BASIC OPERATION
ADVANCED OPERA
TION
APPENDIX
INTRODUCTION
PREPARATION
MAIN SP (main speaker mode)
Choices: LARGE, SMALL
Initial setting: LARGE
LARGE
Select this if you have large main speakers. The entire range
of the left and right main channel signal is directed to the
left and right main speakers.
SMALL
Select this if you have small main speakers. The low-
frequency signals (90 Hz and below) of the main channel
are directed to the speakers selected with BASS OUT.
Note
When you select MAIN for BASS OUT, the low-frequency
signals (90 Hz and below) of the main channel are directed to the
main speakers even if you select SMALL for the main speaker
mode.
REAR LR SP (rear speaker mode)
Choices: LRG (large), SML (small), NON (none)
Initial setting: LRG
LRG
Select this if you have large left and right rear speakers or if
a rear subwoofer is connected to the rear speakers. The
entire range of the rear channel signal is directed to the left
and right rear speakers.
SML
Select this if you have small left and right rear speakers. The
low-frequency signals (90 Hz and below) of the rear
channel are directed to the speakers selected with BASS
OUT.
NON
Select this if you do not have rear speakers.
y
This unit is set in the Virtual CINEMA DSP mode by selecting
NON for REAR LR SP.
SET MENU
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more than
one week, the settings of the SET MENU you adjusted
will return to the factory settings. If so, adjust the items
again.
1 SPEAKER SET (speaker mode
settings)
Use this feature to select suitable output modes for your
speaker configuration.
Notes
When 6CH INPUT is selected as the input source, level
adjustments in items of 1 SPEAKER SET are not affected
(except MAIN LVL).
When 96-kHz sampling digital signals are input to this unit, level
adjustments in items MAIN SP, BASS OUT and MAIN
LVL are possible, but those in items CENTER SP and REAR
LR SP are not affected.
CENTER SP (center speaker mode)
By adding a center speaker to your speaker configuration,
the unit can provide good dialog localization for many
listeners and superior synchronization of sound and images.
Choices: LRG (large), SML (small), NON (none)
Initial setting: LRG
LRG
Select this if you have a large center speaker. The entire
range of the center channel signal is directed to the center
speaker.
SML
Select this if you have a small center speaker. The low-
frequency signals (90 Hz and below) of the center channel
are directed to the speakers selected with BASS OUT.
NON
Select this if you do not have a center speaker. All of the
center channel signals are directed to the left and right main
speakers.
HTR-5450 only
0107HTR5450/5440_32-39_EN 3/28/1, 4:49 PM33