Filter
Top Products
70
TROUBLESHOOTING
■ Remote control
Problem Cause Remedy
Refer to
page
The remote control
does not work nor
function properly.
Wrong distance or angle.
The remote control will function within a
maximum range of 6 m (20 feet) and no more
than 30 degrees off-axis from the front panel.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
Reposition the unit.
The batteries are weak. Replace all batteries with new ones.
The unit or other
component cannot be
controlled.
The component to be controlled has not been
selected.
Set the selector dial to the appropriate position,
corresponding to the component to be
controlled.
The remote control cannot control system
components.
The manufacturer code has not been set up
properly.
Enter the code again.
Try setting another code for the same
manufacturer.
Depending on the manufacturer or the
model, some components cannot be
controlled with this unit’s remote control
even though the code has been set up
properly.
Program functions from the other remote
control’s function into this remote control.
The remote control
does not “learn” new
functions.
The batteries of this remote control and/or
the other remote control are too weak.
Replace the batteries.
The distance between the two remote
controls is too much or too little.
Place the remote controls at the proper
distance.
The signal coding or modulation of the
other remote control is not compatible with
this remote control.
Learning is not possible.
Memory capacity is full. Further learning is not possible without
deleting unnecessary functions.
8
—
3
46
—
51
52
3
52
52
52
After this unit has been exposed to a strong external electric shock (such as lightning and strong static electricity) or if
you mishandle the operation of this unit, it may not function properly. In these cases, set this unit in the standby mode,
disconnect the power cord, plug it back in after 30 seconds, and start operating.