Yamaha HTR-5280 Stereo System User Manual


 
51
English
INTRODUCTION
PREPARATION
BASIC
OPERAIONT
ADVANCED
OPERATION
ADDITIONAL
INFORMATION
APPENDIX
REMOTE CONTROL FEATURES
Setting the Manufacturer Code
You can set up the code for the manufacturer of your
component in each position of the selector dial.
1 Turn on your component to be used.
2 Set the selector dial to the
desired position for the
component (TAPE/MD,
CD, DVD/LD, etc.).
3 Press j / i at the same time for about
4 seconds.
The indicator flashes twice.
4 Use the numeric buttons
to enter the four-digit
manufacturer code for the
component to be used.
Make sure that the
indicator flashes twice.
If the indicator does not flash
or flashes rapidly several
times, repeat step 3 and re-
enter the code.
5 Press AV POWER (or any other button) to
check if you have set up the code correctly.
If your component cannot be
controlled with the remote
control, try setting another
code for the same
manufacturer.
Notes
You can set up only one code for one position.
In the DVD/LD and DVD MENU positions:
Be sure to set the selector dial to the DVD/LD position before
entering the code for the DVD/LD player. The code set up in
the DVD/LD position is also simultaneously set up in the DVD
MENU position. You cannot set up the code for a DVD player
when the selector dial is set to the DVD MENU position.
If your component does not respond to any of the codes listed
for the manufacturer, you can program functions from the other
remote controls functions (see page 52 for details).
If you have already programmed a remote control function to a
button, the function by programming (see page 52) takes
priority over the set up manufacturer codes function.
To use a second (and third) VCR
You can control a second (and third) VCR in the CBL/
SAT and DVD MENU positions if a cable TV/satellite
tuner or DVD player is not being used.
Note
If you want to control a second (and third) VCR in the DVD
MENU position, you must set up the code for an LD player in
the DVD/LD position.
1 Turn on the VCR to be used.
2 Set the selector dial to the
CBL/SAT or DVD MENU
position.
3 Press j / i at the same time for about
4 seconds.
The indicator flashes twice.
4 Use the numeric buttons
to enter the four-digit
code for the second (and
third) VCR. Make sure that
the indicator flashes
twice.
If the indicator does not flash
or flashes rapidly several
times, repeat step 3 and re-
enter the code.
5 Press AV POWER (or any other button) to
check if you have set up the code correctly.
If the VCR cannot be
controlled with the remote
control, try setting another
code for the same
manufacturer.