Yamaha HTR-5280 Stereo System User Manual


 
30
TUNING
Connecting the Antennas
Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal
strength.
Connect each antenna correctly to the designated terminals.
Indoor FM
antenna
(included)
AM loop antenna
(included)
Ground (GND terminal)
For maximum safety and minimum
interference, connect the antenna GND
terminal to a good earth ground. A
good earth ground is a metal stake
driven into moist earth.
Connecting the indoor FM
antenna
Connect the included indoor FM antenna to the 75
UNBAL. FM ANT terminal.
Note
Do not connect an outdoor FM antenna and the indoor FM
antenna at the same time.
DIGITAL OUTPUT
TUNER
DIGITAL INPUT
REMOTE CONTROL
MD/
TAPE
CD-R
CD-R
CD
DVD
FM
ANT
AM
ANT
GND
GND
IN
75
UNBAL.
D-TV
/LD
OPTICAL
OPTICAL
COAXIAL
CD
CBL
/SAT
OUT
5
4
Antenna stand
Connecting the AM loop antenna
1 Press and hold the tab to unlock the terminal
hole.
2 Insert the AM loop antenna lead wires into
the AM ANT and GND terminals.
3 Release the tab to lock the lead wires.
Lightly pull the lead wires to confirm a good
connection.
4 Attach the loop antenna to the antenna
stand.
5 Orient the AM loop antenna so that the best
reception is obtained.
y
The AM loop antenna can be removed from the stand and
attached to a wall, etc.
Notes
The AM loop antenna should be placed away from this unit.
The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
A properly installed outdoor antenna provides clearer
reception than an indoor one. If you experience poor
reception quality, an outdoor antenna may improve the
quality. Consult the nearest authorized YAMAHA
dealer or service center about the outdoor antennas.
FREQUENCY STEP switch (China and general
models only)
Because the interstation frequency spacing
differs in different areas, set the
FREQUENCY STEP switch (locating at
the rear) according to the frequency
spacing in your area.
North, Central and South America:
100 kHz/10 kHz
Other area: 50 kHz/9 kHz
Before setting this switch, disconnect the
AC power plug of this unit from the AC
outlet.
1
2
3
100 kHz/10 kHz
50 kHz/ 9 kHz
FREQUENCY
STEP
FM AM
(U.S.A. model)