Filter
Top Products
English
5
CONNECTIONS
Never plug in this unit and other components until all connections are completed.
➋
Optical fiber cable
(not included)
DIGITAL INCD
OPTICAL
OPTICAL
DIGITAL
AUDIO
OUT
LINE OUT
1
CDC-775
To AC outlet
➊ Connection cord
(included)
Amplifier
Choose one of the ways listed below to connect this unit to your amplifier.
REMOTE CONTROL (IN, OUT) terminals
These terminals are used for custom installation system.
When this unit is connected to the components for custom
installation system, you can operate this unit with the system
remote control.
Connect the REMOTE CONTROL IN terminal of this unit to
the output terminal of the central controller for custom
installation system.
By connecting the REMOTE CONTROL OUT terminal of this
unit to the REMOTE CONTROL IN terminal of the other
component, you can also operate it with the system remote
control. In this way, up to 6 components can be connected in
series.
When the LINE OUT (analog) terminals of this
unit are used (
➊
)
● Be sure that the left (“L”) and right (“R”) LINE OUT terminals
are connected to the corresponding (left and right) terminals
of the amplifier or other components.
● Connect the “LINE OUT” terminals to the “CD” (or “AUX”)
terminals of the amplifier. If the amplifier does not have
such terminals, use the “TAPE PB” terminals. For additional
details concerning these connections, refer to the operating
instructions for the amplifier being used.
● The LINE OUT terminals of this unit are numbered 1. When
connecting this unit with a YAMAHA amplifier or receiver
whose terminals on the rear panel are numbered as 1, 2,
3, etc., connect the LINE OUT terminals of this unit to the
input terminals numbered 1 on the rear of the amplifier or
receiver.
● Before making any connections, switch OFF the power to
the unit and the amplifier or other components.
● Connections should be made to the correct input terminals
of the amplifier or other components.
● If the placement of this unit causes noise in other
equipment, such as a tuner, separate them from each other.
For Custom Installer
For U.S.A., Canada and Australia models of CDC-775 only
When the DIGITAL AUDIO OUT (OPTICAL)
terminal of this unit is used (
➋
)
● Before using this terminal, remove the terminal’s cover by
pulling it.
● Make the connection from this terminal to the optical input
terminal of an amplifier by using a commercially available
optical fiber cable.
* Be sure to use a high quality optical fiber cable. Other
cables might not function correctly.
● This terminal can also be connected to the optical input
terminal of a digital audio tape deck (DAT), etc. to record CD
onto tape directly.
● Be sure to attach the terminal cover when this terminal is not
being used in order to protect the terminal from dust.
● Set the level of signals output into an amplifier to max. by
using the OUTPUT LEVEL buttons.