Filter
Top Products
22
9 Repeat steps 5 and 6 to program more tracks for side B
of the tape.
You can select the same track again.
* If “ERROR” appears in the display, the track number just
selected cannot be programmed because there is no
enough time remaining on side B of the tape.
10 The peak level searching function of this unit is
useful for adjusting recording level on the tape deck.
For peak level searching, when the programming for
side B is finished, press the PROG button and then
press the PEAK button. (Refer to page 24.)
11 Start recording on the tape deck and press the PLAY
button on this unit’s remote control transmitter at the
same time.
12 The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording and,
at the same time, press the PLAY or PAUSE button
on this unit’s remote control transmitter.
Notes
● In steps 7 and 9, even if “ERROR” appears in the display,
you can program another track of which time is shorter than
the remaining time on the side of the tape. At this time, if
any other track number lights up in the display, you can
program it.
● CD synchronized recording function can be used if your tape
deck is compatible with it.
In this case, in steps 11 and 12, press the SYNCHRO button
and then press the PLAY button on this unit’s remote control
transmitter. Recording automatically begins.
(For details, refer to page 20.)
Notes on tape programming
● To check, cancel or correct program data, refer to page 15.
● The maximum number of tracks that can be programmed is
40. If, however, the PAUSE mode is inserted, it is counted
as one track.
● This function can be used to program up to track number 20.
If the disc has more than 20 tracks, tracks with track number
21 and higher cannot be programmed.
■ Manual tape programming
With this function, you can program tracks from one or more
discs in any order to be recorded onto tape.
1 Stop the unit.
2 If you will select tracks from a disc (or discs) other than
the disc on the Disc 1 tray, make this unit display the
total recorded time of each disc to be used by pressing
the DISC SKIP/CHARACTER buttons in turn.
* This unit will read the contents of a disc by this
operation. If there is a disc to which this operation is
omitted, tracks on the disc cannot be programmed.
3 Follow step 4 on page 21.
4
5 If necessary, select a desired disc by pressing the DISC
SKIP/CHARACTER buttons.
6 Select a desired track.
7 Repeat steps 5 and 6 to program more tracks for side A
of the tape. You can select the same track again.
* If “ERROR” appears in the display, the track number just
selected cannot be programmed because there is no
enough time remaining on side A of the tape.
8 When you finish the programming for side A, program
the pause mode by pressing the TAPE button.
* “PAUSE” lights up in the display, and after then you can
begin programming for side B.
12345
67890
+10
INDEX
REPEAT RANDOM TAPE CLEAR
SYNCHRO
PROG
DIMMER TIME
OPEN/
CLOSE
FILE MODEFILE EDIT
TEXT SRCHTEXT MODE
CAPS ENTER
DISC MODE
DISC SCAN OUTPUT LEVEL
SKIP/SEARCH
STOP PAUSE PLAY
DISC SKIP/
CHARACTER
2, 5
6
11, 12
4, 10
12
10
1
8
PEAK
STOP
PROG
PROG
8
TAPE