Filter
Top Products
23
English
Notes
● Because the programmed data changes every time the
RANDOM button is pressed, the amount of time remaining
at the end of the tape also changes accordingly.
● It is recommended that you use a tape that is slightly longer
in length than the CD you are recording, because the
programmed tracks on a CD may not fit properly into the
time allowed on each half of the tape.
● CD synchronized recording function can be used if your tape
deck is compatible with it.
In this case, in steps 3 and 4, press the SYNCHRO button
and then press the PLAY button on this unit’s remote control
transmitter. Recording automatically begins.
(For details, refer to page 20.)
Display information during programming
➀ Shows the number of programmed tracks for each side in
turn just after the automatic programming is finished, and
then it is replaced by the number of the first programmed
track for side A.
➁ Shows the total time of programmed tracks for each side.
➂ Shows the programmed track numbers for each side.
■ Random sequential tape programming
The unit will automatically program tracks on a disc in random
sequential order for recording to tape.
1 Follow steps 1 – 4 on page 21.
2
The unit will automatically program tracks for side A and
side B separately considering the tape’s total time.
* The programmed track numbers and the total
number of tracks for side A and B are displayed for a
short time.
3 Start recording on the tape deck and press the PLAY
button on this unit’s remote control transmitter at the
same time.
4 The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording and,
at the same time, press the PLAY or PAUSE button on
this unit’s remote control transmitter.
Display information during programming
PROG
12345
678910
PROG
12345
678910
➀
➁
➂
➃
RANDOM
12345
67890
+10
INDEX
REPEAT RANDOM TAPE CLEAR
SYNCHRO
PROG
DIMMER TIME
OPEN/
CLOSE
FILE MODEFILE EDIT
TEXT SRCHTEXT MODE
CAPS ENTER
DISC MODE
DISC SCAN OUTPUT LEVEL
SKIP/SEARCH
STOP PAUSE PLAY
DISC SKIP/
CHARACTER
3, 4
4
2
PEAK
PROG
135
7
➀➁
➂
➀Shows the side of the tape and the program number for the
track to be programmed next.
➁ Shows the selected disc and track number.
➂ Shows the total remaining time on the side of the tape.
➃ Programmed track numbers light up and programmable
track numbers among the unprogrammed ones blink.
* If “A-1” does not appear in the display after the PROG
button is pressed, press the TIME display mode-select
button.
* If, during programming, the TIME display mode-select button
is pressed, the program number display can be changed to
display the total remaining time on the side of the tape. To
return to the previous display, press the TIME display mode-
select button once again.