Filter
Top Products
106
REMOTE CONTROL FEATURES
Setting remote control AMP codes
Select one of the following codes to set the remote control
AMP code for the component you want to use.
Set AMP/SOURCE/TV to AMP or SOURCE and then
change the remote control code settings.
• You need to set the corresponding remote control AMP ID
(see page 102).
• When using multiple YAMAHA receivers/amplifiers, you
may be able to operate the other components
simultaneously with the default code setting. In this case,
set one of the alternative codes to operate this unit
separately.
Setting remote control tuner codes
Select one of the following codes to set the remote control
tuner code for the component you want to use.
Set AMP/SOURCE/TV to SOURCE and press TUNER
on the remote control to select TUNER as the input source
and then change the remote control code settings.
• You need to set the corresponding remote control tuner ID
(see page 102).
• When using multiple YAMAHA receivers/amplifiers, you
may be able to operate the other components
simultaneously with the default code setting. In this case,
set one of the alternative codes to operate this unit
separately.
Setting remote control XM codes
Select one of the following codes to set the remote control
XM code for the component you want to use.
Set AMP/SOURCE/TV to SOURCE and press XM on the
remote control to select XM as the input source and then
change the remote control code settings.
• You need to set the corresponding remote control XM ID
(see page 102).
• When using multiple YAMAHA receivers/amplifiers, you
may be able to operate the other components
simultaneously with the default code setting. In this case,
set one of the alternative codes to operate this unit
separately.
5 Press ENTER.
The four-digit code set for the selected component
appears in the display window.
0000 appears in the display window if no code has been set.
6 Press the numeric buttons to enter the
four-digit remote control code for the
component you want to use.
For a complete list of available remote control codes,
refer to “LIST OF REMOTE CONTROL CODES” at
the end of this manual.
7 Press ENTER to set the number.
OK appears in the display window if setting was
successful.
NG appears in the display window if the setting was
unsuccessful. In this case, start over from step 3.
y
If you continuously want to set up another code for another
component, press the input selector button or
SELECT k / n to select the component and then repeat
steps 4 through 6.
AMP library
code
(remote
control
setting)
Function
Remote
control
AMP ID
(this
unit’s setting:
see page 102)
2001
(initial setting)
To operate this unit using
the default code.
To operate Zone 2 or Zone 3
features (see page 115).
ID1
(initial setting)
2002
To operate this unit using an
alternative code.
To operate Zone 2 or Zone 3
features (see page 115).
ID2
Notes
Tuner
library code
(remote
control
setting)
Function
Remote
control
tuner ID
(this unit’s
setting:
see page 102)
2602
(initial setting)
To operate this unit using
the default code.
ID1
(initial setting)
2603
To operate this unit using an
alternative code.
ID2
Notes
XM library
code
(remote
control
setting)
Function
Remote
control XM
ID
(this unit’s
setting:
see page 102)
2604
(initial setting)
To operate this unit using
the default code.
ID1
(initial setting)
2605
To operate this unit using an
alternative code.
ID2
Notes
Note
1
2B
THX
STANDARD SELECT EXTD SUR.
STEREO
MUSIC ENTERTAIN MOVIE
3421
90
+10
ENT.
5678
A
SPEAKERSMEMORY