Filter
Top Products
103 En
Saving and recalling the system settings (System Memory)
ADVANCED
OPERATION
English
If you load the system settings, the settings currently configured
are overwritten. If you do not want to erase the current settings,
save the settings using the System Memory feature in advance.
■ Loading by the
7
SYSTEM MEMORY
buttons
You can recall the system settings stored in “Memory1” to
“Memory4” by pressing the corresponding 7SYSTEM
MEMORY buttons.
1 Press one of the 7SYSTEM MEMORY
buttons on the remote control to select the
desired memory number.
“Memory1 LOAD” (example) appears in the front
panel display.
y
“Empty” appears in the menu screen if no system settings
are stored in the selected memory number.
2 Press the selected
7
SYSTEM MEMORY
button once more to confirm the selection.
This unit loads the settings stored in the selected
memory number.
■ Loading by the GUI menu operation
1 Follow steps 1 to 4 in “Saving by the GUI
menu operation” (page 101).
2 Press 9k / n repeatedly to select “xxx Load”
and then press 9h.
“xxx” indicates the zone you selected in step 1.
3 Press 9k / n repeatedly to select the desired
memory number and then press 9h.
y
If the memory number you selected is empty, “Memory
Empty” appears.
4 Press
9
ENTER to load the settings stored
in the selected memory number.
y
To cancel the operation and return to the previous menu
level, press 9l.
5 Press
I
MENU to turn off the GUI menu.
■ Example 1: Comparing the results of the
automatic setup and manual setup
This unit is equipped with three types of parametric
equalizer settings (page 91), and you can also make your
customized configuration of the sound settings of this unit
by using the “Speaker” parameters (page 87). To compare
the results of the automatic setup or your manual
configuration, use the 7SYSTEM MEMORY buttons.
Saving each setting
1 Perform the automatic setup (page 30).
2 Press and hold
7
SYSTEM MEMORY 1 for
4 seconds.
This unit stores the results of the automatic setup
(PEQ Select: Natural) to “Memory1”.
3 Set “PEQ Select” to “Front” (page 91).
4 Press and hold
7
SYSTEM MEMORY 2 for
4 seconds.
This unit stores the results of the automatic setup
(PEQ Select: Front) to “Memory2”.
5 Configure the parameters of “Speaker”
(page 87) and parametric equalizer
configuration of each speaker manually
(page 91).
6 Press and hold
7
SYSTEM MEMORY 3 for
4 seconds.
This unit stores the settings configured manually to
“Memory3”.
Loading the system settings
Note
4
3
SYSTEM MEMORY
2
1
Using examples
4
3
SYSTEM MEMORY
2
1
SYSTEM MEMORY 1
Results of the automatic setup
(PEQ Select: Natural)
SYSTEM MEMORY 2
Results of the automatic setup
(PEQ Select: Front)
SYSTEM MEMORY 3
Settings configured manually