20
To record a source to tape (or dub from tape to tape)
Notes:
• When the REC OUT selector is set to “SOURCE”, the
source selected by the input selector buttons is output
through the TAPE 1-REC OUT, the TAPE 2-REC
OUT , the VCR 1-OUT, and the VCR 2-OUT
terminals.
• When the REC OUT selector is set to something other
than “SOURCE” and you press an input selector
button other than the one you pressed in step 2, the
recording source will not be changed and you can enjoy
another source while recording.
• To record from tape deck 2, set the REC OUT selector to
SOURCE, and press the TAPE 2/MONITOR input
selector.
• If the tape deck connected to the TAPE 2 REC OUT
terminal has 3-head monitoring capability, you can
monitor the signal just recorded on the tape by pressing
the TAPE 2/MONITOR switch.
• DSP, VOLUME, BASS, TREBLE and BALANCE
control settings have no effect on the material being
recorded.
• Signals connected to the 5CH DISCRT INPUT are not
output to the tape decks or video recorders.
To record the signals from an LD player, you must
connect the player to the LD/TV terminals.
• It is possible for someone in the second room to
use the Room 2 Remote transmitter to change the
source you selected for recording. For example, if
you are recording a program from the tuner and
the person in the second room changes the
station. If you are listening to another source, you
may not discover this error until you playback the
recording.
1
2
1 Select the source to be recorded.
2
3
Play the source and press the corresponding input
selector, then turn the VOLUME control up to confirm
the input source. (For detailed information on the tuning
operations, refer to page 22.)
REC OUT
LD/TV
VCR 1
TAPE 1
TUNER
CD
PHONO
VIDEO AUX
VCR 2
SOURCE
Set the tape deck or VCR to the recording mode.
VOLUME
l6
l8
20
24
28
34
40
50
60
70
l4
l2
l0
8
6
4
3
2
l
0
–dB
4
To monitor a source selected by the REC OUT selector,
press the corresponding input selector button.
VIDEO AUX
VCR 2 VCR 1
LD/TV
TAPE 2
MONITOR
TUNER CD PHONO
TAPE 1