Filter
Top Products
12
10dB
0dB
-
OFF
ON
MONITOR
OUT
IN OUT
TAPE 2
REC
OUT
5ch
7ch
FRONT
MIX
MAIN
IN
MAIN CH
MAIN
LEVEL
PRE
OUT
AUDIO
PRE OUT
VIDEO
OUT
LD/TV
CENTER
LD/TV
SURROUND
5CH
DISCRT
INPUT
LD/TV
MAIN
REMOTE CONTROLROOM 2 OUT
6
5
A
9
8
7
0
5MAIN␣ CH — MAIN␣ IN terminals
These terminals are for line input to the built-in
main channel amplifier. Leave the jumper bars
connected to the PRE␣ OUT terminals when you use
the built-in amplifier.
However, if you drive main speakers with an
external stereo power amplifier, remove the
jumper bars.
6MAIN␣ CH — PRE␣ OUT terminals
These terminals are for main channel line output.
Leave the jumper bars connected to the MAIN␣ IN
terminals when you use the built-in amplifier.
However, if you drive main speakers with an
external stereo power amplifier, remove the
jumper bars and connect the input terminals of the
external amplifier (MAIN IN or AUX terminals of
a power amplifier or an integrated amplifier) to
these terminals.
7MAIN LEVEL switch
Normally set to “0␣ dB”. If desired, you can de-
crease the output level at the MAIN SPEAKERS
terminals by 10␣ dB by setting this switch to
“–10␣ dB”.
8ROOM 2 OUT — AUDIO PRE OUT, VIDEO
OUT terminals
These terminals output audio and video signals to
the equipment in the second room. The signal
source is selected using the Room 2 Remote
transmitter. Refer to “Connecting to Room 2
Equipment” on page 14.
9REMOTE CONTROL — IN, OUT terminals
IN This terminal receives the commands from
the Room 2 Remote transmitter.
OUT This terminal outputs the commands at the
IN terminal from Room 2 Remote transmit-
ter. Refer to “Connecting to Room 2 Equip-
ment” on page 14.
0FRONT MIX switch
This switch should be set to match the number of
speakers in your system. For seven speaker
configurations, set it to “7 ch”. For five speaker
configurations, set it to “5 ch”.
A5CH DISCRT INPUT terminals
These terminals are used with a Dolby Surround
AC-3 decoder. Connect the main audio output of
the decoder to the LD/TV MAIN input terminals,
the center channel audio output to the LD/TV
CENTER input terminal, and the surround audio
output to the LD/TV SURROUND input termi-
nals.
Note:
5CH DISCRT INPUT terminals can only be used with an
AC-3 decoder.
When you use a Dolby Surround AC-3 decoder, the LFE
(Low Frequency Effect channel) signal coming from the
AC-3 decoder to this unit must be mixed with the main
output signal. Refer to your AC-3 decoder’s operating
manual for information about mixing these signals mode.