Yamaha RX-397 Stereo Receiver User Manual


 
CONTROLS AND FUNCTIONS
7
INTRODUCTION
This section describes the function of each button on the
remote control used to control this unit or other
components made by YAMAHA. The functions of the
buttons used to control your other audio components are
the same as those of the corresponding buttons on those
components. Refer to those components’ instruction
manuals for details.
1 Infrared signal transmitter
Sends infrared signals.
2 SLEEP
Sets the sleep timer.
3 Input selector buttons
Select the desired input source.
4 PRESET u / d
Selects the preset station number (1 to 8) when TUNER is
selected as the input source.
5 A/B/C/D/E
Selects the preset station group (A to E) when TUNER is
selected as the input source.
6 Radio Data System/CD player/Cassette tape
deck control buttons
Controls Radio Data System features, YAMAHA CD
players or YAMAHA cassette tape deck.
The Radio Data System features (FREQ/TEXT, PTY SEEK
MODE and PTY SEEK START) are only applicable to the
Europe model and are operational only when TUNER is selected
as the input source and the AMP/DEVICE switch is slid to the
AMP position.
7 AMP/DEVICE switch
Switches the function of the control buttons numbered 6
between controlling this unit and controlling YAMAHA
CD players or YAMAHA cassette tape deck.
8 POWER
Turns on this unit.
9 STANDBY
Sets this unit to the standby mode.
In the standby mode, this unit consumes a small amount of power
to receive infrared signals from the remote control.
0 SPEAKERS A/B
Turns on or off the set of speakers connected to the
SPEAKERS A and/or SPEAKERS B terminals on the rear
panel of this unit when the corresponding button is
pressed each time.
A VOLUME +/–
Increases or decreases the sound output level.
This does not affect the OUT (REC) level.
When you press VOLUME +/– to control the sound output
level of this unit, VOLUME on the front panel rotates.
B MUTE
Mutes the sound output. Press again to restore the sound
output to the previous volume level (see page 19).
C CD/TAPE switch
Switches the function of the control buttons numbered 6
between controlling YAMAHA CD players and
controlling YAMAHA cassette tape deck when the AMP/
DEVICE switch is slid to the DEVICE position.
Remote control
CD/DVD PHONO TUNER
MD TAPE AUX
SPEAKERS
B
A
POWER
STANDBY
+
u
d
SLEEP
REC
EON
FREQ/TEXT
MODE STARTPTY SEEK
A/B
DISC
DIR A
p
DIR B
A/B/C/D/E
MUTE
PRESET
VOLUME
TAPECD
DEVICE
AMP
w
e
f
b
s
a
DISPLAY
8
9
0
A
B
C
1
3
7
6
4
5
2
Note
Note
Notes