Filter
Top Products
35 En
TROUBLESHOOTING
ADDITIONAL
INFORMATION
■ iPhone/iPod
The following messages may be displayed on the front panel display in certain situations.
Message Status/Cause Remedy
See
page
Connect error There is a problem with the signal path
from your iPhone/iPod to the unit.
Turn off the unit and reconnect the Universal Dock
for iPod to the DOCK jack of the unit.
24
Remove your iPhone/iPod from the Universal Dock
for iPod and then place it back in the dock.
24
Unknown iPod The iPhone/iPod being used is not
supported by the unit.
Connect an iPhone/iPod supported by the unit.
24
Connected Your iPhone/iPod is properly placed in
the Universal Dock for iPod.
—
Your iPhone/iPod is properly placed in
the Wireless System for iPod and
connected with this unit via wireless
transmission.
26
Disconnected Your iPhone/iPod is removed from the
Universal Dock for iPod.
—
Your iPhone/iPod is disconnected with
this unit via wireless transmission.
—
The wireless connection is poor. Place the YID-W10 receiver as far away from this
unit as possible.
24
Problem Cause Remedy
See
page
When using the
Universal Dock for
iPod:
Your iPhone/iPod is
not being charged
even though it is
connected to the
Universal Dock for
iPod.
This unit is not turned on. Turn on this unit or set it to standby mode.
4, 8
The iPhone/iPod is not connected
securely.
Connect the iPhone/iPod securely to the Universal
Dock for iPod.
—
When using the
Wireless System for
iPod:
Your iPhone/iPod is
not being charged
even though the YID-
W10 transmitter
connected to your
iPhone/iPod is
stationed in the YID-
W10 receiver.
This unit is not turned on. Turn on this unit or set it to standby mode.
4, 8
The YID-W10 transmitter is not stationed
securely in the YID-W10 receiver.
Station the YID-W10 transmitter connected to your
iPhone/iPod securely in the YID-W10 receiver.
—