Filter
Top Products
CONTROLS AND FUNCTIONS
7 En
INTRODUCTION
CONTROLS AND FUNCTIONS
Rear panel
1 REMOTE IN/OUT jacks
Used to send and receive remote control signals (see page
13).
2 GND terminal
Used to connect a turntable (see page 10).
3 TAPE jacks
Used to connect a tape deck (see page 10).
4 Antenna terminals
Used to connect FM and AM antennas (see page 12).
5 DOCK jack
Used to connect an optional Yamaha Universal Dock for
iPod (such as the YDS-12), Wireless System for iPod
(YID-W10), or Bluetooth Wireless Audio Receiver
(YBA-10) (see page 24).
6 Power cable
For connecting this unit to an AC wall outlet (see page
13).
7 PHONO jacks
Used to connect a turntable (see page 10).
8 CD jacks
Used to connect a CD player (see page 10).
9 LINE 1-2 jacks
Used to connect audio components (see page 10).
0 SUBWOOFER OUT jack
Used to connect a subwoofer with built-in amplifier (see
page 10).
A POWER MANAGEMENT switch
Used to enable or disable the automatic power down
function. When this function is enabled, this unit
automatically enters standby mode if it is not operated for
a certain amount of time (3 settings are available; see page
31).
B SPEAKERS terminals
Used to connect speakers (see page 10).
C IMPEDANCE SELECTOR switch
Used to select the impedance setting (see page 11).