Yamaha NS-P116 Speaker System User Manual


 
English
E-5
Mounting the front/rear speakers (and rear center speaker for
NS-P116)
Mount the front/rear speakers (and rear center speaker for
NS-P116) on a shelf, rack or directly on the floor, or hang
them on the wall.
To mount the speakers on a wall by
using the holes on the speakers’
back panels
1 Fasten screws into a firm wall or wall support as shown
in the figure.
2 Hang the speaker by mounting the holes on the
protruding screws.
* Make sure that the screws are securely affixed by the
narrow parts of the holes.
WARNING
Each speaker weighs 0.9 kg (2 lbs.). Do not mount
them on thin plywood or a wall composed of a soft
surface material. If mounted, the screws may pull out
of the flimsy surface and the speakers may fall. This
may damage the speakers or cause personal injury.
Do not affix the speakers to a wall using nails,
adhesives, or any other unstable hardware. Long-
term use and vibrations may cause the speakers to
fall.
To avoid accidents resulting from tripping over loose
speaker cables, fix the cables to the wall.
Select an appropriate position on the wall to mount
the speaker so that no one will injure his/her head or
face.
1
70 mm
Holes
2
Wall/ wall
support
Tapping screw
(Available at the
hardware store)
Min.
20 mm
Diam. 3.5 to 4 mm
10 mm
70 mm
70 mm
Using the Yamaha Speaker Stand SPS-80 (option)
By using the Yamaha Speaker
Stand SPS-80, speakers can be
placed on the floor.
* The SPS-80 is not available in some areas.
SPS-80
2-NS-P110-116-U.p65 05.3.11, 4:27 PM5