Filter
Top Products
25
CONNECTIONS
PREPARATION
If you are using 6 ohm speakers, set the impedance to
6 ohms as follows before turning on the power.
Be sure this unit is in the standby mode.
1 On the front panel, while holding down
SPEAKERS A, press STANDBY/ON.
“SP IMP.SET” appears in the front panel display for a
few seconds, then “Minimum 8ohms” appears.
2 Press SPEAKERS A or SPEAKERS B to
select the impedance of your speakers.
You can select either 6 ohms or 8 ohms.
3 Press STANDBY/ON to exit the setting.
This unit will be set to the standby mode.
y
You can also use SP IMP.SET (see page 63) to set the speaker
impedance.
When all connections are complete, turn on the power of
this unit.
1 Press STANDBY/ON (SYSTEM POWER on the
remote control) to turn on the power of this
unit.
2 Turn on the video monitor connected to this
unit.
Press STANDBY/ON again (STANDBY on the remote control)
to enter the standby mode.
Speaker impedance setting
CAUTION
STANDBY
/ON
SP IMP.SET
Minimum 8ohms
SPEAKERS
A
Turning on the power
Note
PRESET/TUNING
EDIT
FM/AM
A/B/C/D/E
PRESET/TUNING
INPUT MODE
TONE CONTROL
MULTI CH
INPUT
STRAIGHT
EFFECT
MEMORY
MAN'L/AUTO FM
TUNING MODE
AUTO/MAN'L MONO
VOLUME
PROGRAM INPUT
STANDBY
/ON
OPTIMIZER
MIC
PHONES
SILENT CINEMA
SPEAKERS
A B
OPTICALRAUDI OL
VIDEO
S VIDEO
VIDEO AUX
PURE DIRECT
A/B/C/D/E
1
SELECT
DTV DVR/VCR2VCR 1 DVD
V
-
AUX
CBL/SAT MD/TAPE
CD-R
PHONO TUNER CD
MULTI CH IN
+
POWER POWER POWER
SYSTEM
STANDBY
AVTV
SLEEP
INPUT MODE
A
B
++
AMP
1
STANDBY
/ON
POWER
SYSTEM
or
Front panel
Remote control
01EN00_HTR5890U.book Page 25 Thursday, December 23, 2004 12:39 PM