Filter
Top Products
14
Caution: Plug in this unit and other components after all connections are completed.
All connections must be correct, that is to say L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. Also refer to the owner’s manual for
each of your components.
Audio/video source equipment
●
Use RCA type pin plug cables for audio/video units with the exception described later.
●
The output (or input) terminals of YAMAHA audio/video units numbered as 1, 3, 4, etc. on the rear panel must be connected to
the same-numbered terminals of this unit.
PHONO CD
TAPE
/
MD DVD/LD TV/DBS VCR
IN OUT
1 3 4
AUDIO SIGNAL
FM
ANT
AM
ANT
75
Ω
UNBAL.
GND
SUB
WOOFER
DVD/LD
COAXIALOPTICAL OPTICAL
DVD/LD TV/DBSCD
DIGITAL SIGNAL
IN (PLAY) OUT (REC)
EXTERNAL DECODER INPUT
MAIN CENTER
SURROUND
GND
VIDEO SIGNAL
MONITOR
OUT
DVD/LD TV/DBS
IN OUT
VCR
MONITOR
OUT
DVD/LD
IN OUT
VCR
S VIDEO SIGNAL
OUTPUT
LINE OUT
LINE IN
VIDEO OUT
AUDIO OUT
AUDIO OUT
AUDIO IN
VIDEO OUT
VIDEO IN
OUTPUT
GND
VIDEO
IN
AUDIO OUT
VIDEO OUT
ON SCREEN SELECTOR
S VIDEO VIDEO
REMOTE
CONTROL
IN OUT
(U.S.A. model)
Turntable
MD recorder,
Tape deck, etc.
CD player
Ⅵ Basic connections
(*1): GND terminal (For turntable use)
Connecting the ground wire of the turntable to the GND
terminal will normally minimize hum, but in some cases
better results may be obtained with the ground wire
disconnected.
: Indicates the direction of signals.
Connections
PREPARATION
(*1)
LD player, DVD player, etc.
TV monitor
Video cassette
recorder
TV/Satellite tuner