Filter
Top Products
34
EXCHANGING PRESET STATIONS
You can exchange the assigment of two preset stations with each other as shown below.
3 Next, recall preset station “A5” by following the same
procedure as in step 1.
Flashes
4 Press EDIT once more.
Front Panel
Shows the exchange of
stations has been
completed.
Notes
• You can manually replace a preset station with another FM or AM station by simply following the procedure in the section “To
store stations” on page 31.
• An automatic preset tuning search will be performed through all RDS network frequencies until stations have been stored up to
E8. Even if the number of received stations is not enough to be stored up to E8, the search is automatically ended after
searching all frequencies.
• With this function, only RDS stations with sufficient signal strength are automatically stored. If the station you want to store is
weak in signal strength, tune in to it manually in monaural sound and store it by following the procedure in the section “To store
stations” on page 31.
* There may be a case that this function cannot receive a station which could be received by the automatic tuning method. This
is because this function receives a large volume of PI (Program Identification) data along with the station.
Example
If you want to change the preset station from “E1” to “A5”, or vice versa.
2,4
1 Recall preset station “E1” by following the procedure in
the section “To recall a preset station” on page 32.
2 Press EDIT.
Front Panel
Flashes
01RX-V495RDS-3 6/22/99, 12:28 PM34