Filter
Top Products
E-20
DIGITAL SOUND FIELD PROCESSOR (DSP) EFFECT
Selecting a DSP Program
You can enhance your listening experience by selecting a
DSP program. Refer to pages 22 to 24 for details about each
program.
1 Make sure that the effect speakers (center and
rear) and subwoofer are turned on.
2 Press PROGRAM l or h repeatedly (or one of
the PROGRAM selector buttons) to select the
desired program.
The name of the selected program appears on the
display.
y
If desired, adjust the delay time and the sound output level of each
speaker. (Refer to pages 29 and 30 for details.)
Notes
• You can select a DSP program for each of the input sources. Once
you select a program, it is linked with the input source selected at
that time. So, when you select the input source next time, the
same program is automatically selected.
• When a monaural source is being played with PRO LOGIC/
Normal or PRO LOGIC/ENHANCED, no sound will be heard
from the main speakers and the rear speakers. Sound can only be
heard from the center speaker. However, if “CENTER SP” on the
SET MENU is set to the NONE position, the center channel
sound is output from the main speakers.
• When a source connected to the 6CH INPUT terminals of this
unit is selected, the digital sound field processor cannot be used.
• When high-rate 96-kHz sampling 24-bit digital signals are input
to this unit, no DSP program can be selected and the sound is only
output from right and left main speakers as a normal 2-channel
stereo sound.
PROGRAM
PRO LOGIC
DSP
MOVIE THEATER 2
DVD/LD
D–TV
VCR
TUNER
CD
CBL/SAT
PROGRAM
/DTS
SUR.
21
4
MOVIE
THTR 1
3
MOVIE
THTR 2
MONO MOVIE
7
ROCK
5
TV SPORTS
8
HALL
6
DISCO
Canceling the Sound Effect (turning
off the effect speakers)
Press EFFECT to cancel the sound effect and
monitor only the main sound.
Press EFFECT again to turn the sound effect back on.
Notes
• If you turn off the sound effect when Dolby Digital or DTS is
decoding, the sounds of the center and rear channels are mixed
and output from the main speakers.
• If you turn off the sound effect when Dolby Digital or DTS is
decoding, it may happen that the sound is output faintly or not
output normally, depending on the source. In this case, turn sound
effect back on.
EFFECT
Front panel
EFFECT
Remote control
STANDBY/ON
INPUT MODE
INPUT SELECTOR
VOLUME
16
20
28
40
60
00 0
2
4
8
12
–dB
PROGRAMSET MENU
EFFECTTAPE/MD MON
/6CH INPUT
NEXT
+–
NATURAL
SOUND AV PROCESSOR/AMPLIFIER DSP–E800
CINEMA DSP
DOLBY
DIGITAL
DIGITAL
SURROUND
2
POWER
PROGRAM
/DTS
SUR.
21
4
MOVIE
THTR 1
3
MOVIE
THTR 2
MONO MOVIE
7
ROCK
TEST
TIME
/
LEVEL
6CH INPUT
SET MENU
5
TV SPORTS
8
HALL
6
DISCO
EFFECT
DSP
CD TUNER TAPE
/
MD
2
Front panel Remote control
or
DSP program name
or
104.E800_16-20(Eng) 5/18/0, 1:37 PM20