Filter
Top Products
Chapter 3 - Installing the Yamaha CRW4416SX Drive
7
Chapter 3 -
Installing the Yamaha CRW4416SX Drive
CRW4416SX drive settings
■ SCSI ID settings
The SCSI ID number is used so that the computer will recognize a con-
nected SCSI device. You can assign 0 through 7 as the SCSI ID num-
ber. Usually, “7” is reserved for the SCSI card ID number, and “0” is
reserved for the first SCSI device in the chain. Use a number between 1
and 6 for the CRW4416SX.
Use the switch on the rear panel to set a SCSI ID number. The factory
set ID number is “1”.
Caution: If you are using other SCSI devices, be sure to use a unique ID number
for each device. Be sure to turn off the power to the drive before you set
the SCSI ID number.
Note: When you are using Windows 95 or Windows 98, and if the SCSI ID
setting on the rear panel is the same as the number assigned to another
SCSI device, the Plug and Play component of Windows 95 or Windows
98 will automatically assign an unused number to the CRW4416SX
(SCAM protocol level 1).
CDR ID
1
–
+
Pressing this switch repeatedly
will decrease the SCSI ID
number by one each time.
Pressing this switch repeatedly
will increase the SCSI ID
number by one each time.
SCSI ID Number