Filter
Top Products
4 En
CONTROLS AND FUNCTIONS
Before making any connection, switch OFF the power to the unit, the amplifier and any other component.
■ VOLTAGE SELECTOR
(Asia and General models only)
The VOLTAGE SELECTOR on the rear panel of this unit
must be set for your local voltage BEFORE plugging the
power cable into the AC wall outlet. Improper setting of
the VOLTAGE SELECTOR may cause damage to this
unit and create a potential fire hazard.
Rotate the VOLTAGE SELECTOR clockwise or
counterclockwise to the correct position using a straight
slot screwdriver.
Voltages are as follows:
...............AC 110/120/220/230-240 V, 50/60 Hz
Rear panel connections
CAUTION
Optical digital
cable
Audio cable
(supplied)
Amplifier
Connect the supplied power
cable into the AC IN inlet on
the rear panel when all
connections are complete,
and then plug in the power
cable to the AC outlet.
AC IN inlet
REMOTE CONTROL
IN/OUT terminals
RS-232C terminal
The audio signals are only output from the ANALOG OUT
jacks when the PURE DIRECT mode is on.
CAUTION
230-
240V
VOLTAGE
SELECTOR
Voltage indication
For Custom Installer
■ REMOTE CONTROL IN/OUT terminals
These terminals are used for custom installation system. When this unit is connected to the components for custom
installation system, you can operate this unit with the system remote control.
Connect the REMOTE CONTROL IN terminal of this unit to the output terminal of the central controller for custom
installation system.
By connecting the REMOTE CONTROL OUT terminal of this unit to the input terminal for remote control of the
other component, you can also operate it with the system remote control. In this way, up to 6 components can be
connected in series.
■ RS-232C terminal
This unit is also equipped with an RS-232C terminal. Consult your dealer for details.