Filter
Top Products
OPERATION
12
Once you have finished all cable connections (pages 8-10) and remote control preparation (page 11), follow the
procedure below to start from basic playback operation.
1 Press STANDBY/ON ( ).
This unit turns on and the indicators on the front
panel light up.
y
This unit has the auto-sleep function which automatically
switches to the standby mode if you do not operate the unit
for about 24 hours while the unit is turned on.
2 Press one of the INPUT buttons (1 to 4) to
select an input source.
For example, if the DVD-S30 is connected to the
INPUT (1) jack on the rear panel of this unit, press
INPUT (1) to select the DVD-S30.
3 Start playback on the selected external
component.
For information on the external component, refer to
the manual for that product.
4 Press VOLUME +/– to adjust the volume
level.
y
To turn off the volume temporarily, press MUTE. While the
mute function is on, the Input indicators (other than one
currently selected) blink. To disable the mute function, press
MUTE once again.
Now, please try various features of this unit!
To enjoy high realistic sensational sounds with a DSP
program
→ “Enjoying realistic sounds (CINEMA DSP)” (page 13)
To enjoy stereo sounds such as CD audio with virtual
multi channels
→ “Enjoying stereo sounds with multi speaker channels (Dolby
Pro Logic II)” (page 13)
To enjoy virtual surround sounds with the DVS function
→ “Using the DVS function (Dolby Virtual Speaker)” (page 13)
To configure the orientation of virtual surround
speakers
→ “Adjusting the Orientation of the Virtual Surround Speakers”
(page 16)
OPERATION
Basic Operation
STANDBY/ON
STANDBY/ON
DVD
09
5678
4
43
21
321
REPEAT SUBTITLEAUDIO
ZOOM
SHIFT
TV INPUT
DUAL MONO
TV CH
SETUP
RETURNMENU
VOLUME
TV VOL
MUTE
NIGHT
TEST
INPUT
LR
MODE
MOVIE SPORTS GAMEMUSIC
ENTER
ON SCREEN
qVS
TV
ANGLE
SW CENTER SURR
A-B
STANDBY/ON
()
INPUT
buttons
VOLUME
+/–
MUTE