Filter
Top Products
61
SET MENU
ADVANCED
OPERATION
■ Input rename C)INPUT RENAME
Use this feature to change the name of the inputs in the
front panel display.
1 Press an input selector button to select the
input you want to change the name of.
2 Press AMP.
3 Press j / i to place the _ (under-bar) under
the space or the character you want to edit.
4 Press u / d to select the character you want,
then use j / i to move to the next space.
• You can use up to 8 characters for each input.
• Press d to change the character in the following
order, or press u to go in the reverse order:
A to Z, a space, 0 to 9, a space, a to z, a space,
symbols (#, *, –, +, etc.).
5 Repeat steps 1 through 4 to rename each
input.
6 To exit, press SET MENU when finished.
Use to adjust the optional system parameters.
■ Display settings A)DISPLAY SET
Dimmer DIMMER
Use to adjust the brightness of the front panel display.
Choices: –4 to 0
Video conversion V. CONV.
Use this feature to turn on/off conversion of composite
(VIDEO) signals to S-video signals. This allows you to
output converted video signals from the S VIDEO jacks
when no S-video or component signals are input. This
feature also converts S-video signals to component signals
when no component signals are input.
Choices: ON, OFF
• Select OFF not to convert any signals (except S-video
signals to composite signals).
• Select ON to convert composite signals to S-video and
component signals, and to convert S-video signals to
component signals.
• Regardless of the setting, S-video signals are always
converted to composite signals.
• Converted video signals are only output to the MONITOR OUT
jacks. When recording you must make the same type of video
connections (i.e., S-video) between each component.
• When converting composite video or S-video signals from a
VCR to component signals, the picture quality may suffer
depending on your VCR.
■ Memory guard B)MEMORY GUARD
Use this feature to prevent accidental changes to DSP
program parameter values and other system settings.
Choices: ON, OFF
Select ON to protect:
• DSP program parameters
• All SET MENU items
• All speaker levels
When MEMORY GUARD is set to ON, you cannot select any
other SET MENU items.
3 OPTION MENU
Notes
Note