XM Satellite Radio SR9600A Satellite Radio User Manual


  Open as PDF
of 6
 
3
ENGLISH
SIGNAL : STRONG SIGNAL : MARGINAL
Signal strength is good Signal strength is marginal
SIGNAL : WEAK SIGNAL : NON
Signal strength is poor Loss of the signal
2.
Adjust the antenna location until Signal
strength is good.
3.
Turn the GYRO TUNING dial or tap the channel
or button on the remote control unit to
select channel 0 (XM000).
• The Radio ID is displayed.
Note:
• If “CHECK ANTENNA” appears in the front
panel display, the XM Connect-and-Play antenna
may not be connected to the XM terminal on the
rear panel of this unit properly.
LISTENING TO XM SATELLITE RADIO
SELECTING AN INPUT SOURCE
Before you can listen to XM Satellite Radio, you
must first select the input source on the SR9600.
MULTI
SPEAKER
F/PBANDTHXTHXPURE DIRECTPURE DIRECT UP
DOWN
TUNING
AUX 1 INPUT
RAUDIO
DIGITAL S-VIDEO
LVIDEO
POWER ON/STANDBYPOWER ON/STANDBY
VOLUME
UPDOWN
INPUT SELECTORINPUT SELECTOR
PHONESPHONES
STANDBYSTANDBY
AV SURROUND RECEIVER SR9600AV SURROUND RECEIVER SR9600
SURROUNDSURROUND
MIC
ENTER
MENU
PURE DIRECTPURE DIRECT THXTHX
7.17.1CH INPUT
MODEMODE AUTOAUTO
MULTIMULTI
A/B
T-MODE
MEMORY CLEAR
DISPLAY
EXIT
SPEAKERS
MRAC
AUTO TUNE
1.
1.
Select “XM” by turning the INPUT SELECTOR
knob on the front panel.
Or, tap the “XM” on the remote control unit.
CHECKING THE XM SIGNAL STRENGTH AND
RADIO ID
1.
Tap the Disp. twice on the remote control
unit. Signal status is displayed.
• The display changes as shown below
according to the receiving condition.
SWITCHING XM INFORMATION IN THE FRONT
PANEL DISPLAY
You can display XM information (such as artist
name, song title, category or signal status) for the
channel currently selected in the front panel
display.
1.
Tap the Disp. button on the remote control
unit repeatedly to toggle between the
following channel information display modes.
Artist name/Song title
Channel category
Signal Status
Surround mode (OSD ON)
When the channel Artist name/Song title is
displayed:
When the channel category is displayed:
When the signal status is displayed:
Radio ID
DIGITAL
1/8 A/V Amp
Source Select
wed Jun 01 4:40
pm
1.
1/2 XM
XM : Main
wed Jun 01 4:40pm
1.
1/2 XM
XM : Main
wed Jun 01 4:40
pm
1.
When the Surround mode is displayed:
The video monitor output will show OSD information.
Note:
•
The front panel display can indicate up to 20
alphanumeric characters at once. If the information
contains more than 20 characters, the information
scrolls from right to left.
• If the information contains a character that cannot
be recognized by that unit, the character will be
displayed with “ ” (space).
XM I NFORMAT ION
X
C
N
T
C
S
M
H
A
I
A
I
A
M
T
T
G
N
E
L
N
E
AL
:
:
:
:
:
:
0
D
P
M
R
S
4
e
i
o
o
T
0
e
n
n
c
R
p
k
ey
k
O
T
N
r
F
G
a
l
c
o
k
i
s
d
06.1.16, 4:44 PMPage 3
 previous next