Filter
Top Products
Model PA4100X Page 13
© 2003 Xantech Corporation
TROUBLE SHOOTING
If you encounter a problem, please review the items in the following list. Be sure, in addition, to check other system
components, such as preamplifiers, CD players, speakers, speaker wiring, etc., that may be at fault.
PROBLEM PROBABLE CAUSE AND SOLUTION
Rear panel Power Indicator does not light – no sound. Check line cord for good contact in a live AC outlet. If
REMOTE CI jacks are being used, be sure applied
voltage is between +5V and +30V DC with proper
polarity. See Fig. 6.
Sound cuts in and out every 3 to 5 seconds. Speaker load impedance is less than 4-Ohms for
Stereo mode or less than 8-Ohms for Bridged mode.
Make changes in speakers as necessary to obtain
higher impedance.
PA4100X does not turn OFF when both REMOTE input
voltages go to 0 Volts. The Logo stays illuminated.
Be sure that the CI Switch (item 14, Fig. 3) is set to the
CI ON (UP) position.
PA4100X becomes very warm, shuts OFF, but does
not come back ON automatically.
Set POWER switch (item 2, Fig. 2) to MANUAL OFF
(OUT) position for 15 seconds, then back ON. If
REMOTE ON/OFF jack is used, unplug for 15 seconds,
then re-plug with Front Power OFF.
One or more front panel LED’s glow red. The amplifier has been driven into clipping and/or is
overheating. Correct faulty condition.