Filter
Top Products
Page 10
The headset and transmitter in this package are “paired”, which means they’re
synchronized to ensure they work together. When the headset and transmitter are
communicating, the top LED on the front panel of the transmitter will be on solid. If
this LED is instead slowly pulsing, it means the transmitter can’t communicate with
the headset. This could happen if the headset is turned off or out of range. If the LED
is slowly pulsing when the headset is on and within range, then they might need to be
“paired” as described below:
After a few seconds, the topmost transmitter LED should be on solid and the headset
LED should be ashing about once per second, indicating that the units are paired.
Interference from Two Headsets
Only one headset can be paired with the transmitter. If you pair two headsets with the
same transmitter, they’ll interfere with each other as they compete for the transmitter
RF signal. This will cause one headset to shut off. So don’t try to pair two headsets
with the same transmitter!
Pairing the X41 Headset and Transmitter
Step 1:
Make sure the headset is
off by pressing the “Power”
button until the LED turns on,
and then release it. Make sure
the headset LED is off.
Step 2:
Then press and hold the
headset power button until
the LED turns on solid and
release the button when the
LED turns off. The headset
LED will start to ash rapidly.
Step 3:
Press and hold the transmitter
“Bypass” button for 5 seconds
until the topmost LED on the
transmitter turns off, then release
the button. The transmitter LED
will then ash rapidly.
EFFECTS
POWER