Filter
Top Products
8
HINT: You can also further adjust the speed or time, by holding
down the TAP button and turning the EDIT 1 knob.
(This is the EDIT 2 mode)
NOTE:If the BYPASS LED is lit, you won’t be able to use the
TAP switch to set the time. (The TAP LED will be dark.)
NOTE:If you turn off the power to the unit, the value set by the
TAP button will be reset to its initial value.
BYPASS (EDIT 3) and LED
If you don’t want to use an effect, press this button to
turn the effect off (i.e., bypassed). If the effect is by-
passed, this LED will be lit.
NOTE:You can’t adjust the effect parameters if the BYPASS
LED is lit.
HINT: While the effect is bypassed, you can adjust the noise
reduction sensitivity by holding down the TAP button
and turning the EDIT 1 knob.
HINT: The bypass setting is remembered even when you switch
modes, switch programs, or turn off the power.
HINT: The Bypass button can be used to modify effect param-
eters (EDIT 3). Press and hold Bypass and simulta-
neously turn the EDIT 1 knob. See the chart on page 14
for what parameters can be controlled.
B. Rear Panel
1 2 3 4 5 6 7
1. POWER SELECT
This switch adjusts the output wattage of the power
amp. This means that even when the master volume
is turned up to max to drive the power amp, you can
adjust the volume without losing any tone or feel.
2. LINE/PHONE jack
Use this jack if you’re plugging directly in to a mixer,
recording device, or if you’re using headphones.The
output signal from this jack is taken before the power
amp, and the character of the guitar amp cabinet is
applied to it.
NOTE:Connecting headphones to this jack will mute the inter-
nal speaker.