8
TREBLE, MIDDLE, and BASS
This trio of knobs allows you to dial in the exact amount of high, mid, and low fre-
quencies. Also, as you’d expect (and hope!), the exact manner in which each one
of these controls behaves and also interacts with the others is dependant on the
type of sound selected. Turn to the “Sound Styles and Effects” section (page 18)
for more information.
MASTER
This adjusts the overall volume. This setting will vary the amount of distortion cre-
ated by the power amp.
NOTE:
The MASTER volume control is NOT programmable.
NOTE:
The GAIN control also affects the amount of distortion. For some settings,
there may be virtually no distortion.
3. E
FFECT
SECTION
Here you can make settings for effects and noise reduction. For details on each effect,
refer to “Sound Styles and Effects” (page 18).
EFFECTS
Selects the type of effect. You can use the TAP button, EDIT 1 knob and Bypass
button to adjust the parameters of each effect. When you select an effect type, the
effect parameters will be initialized and Effect Bypass will be defeated.
EDIT 1
Use this to adjust the parameters of each effect. By using this knob in conjunction
with the TAP and BYPASS buttons as described below, you can adjust three differ-
ent parameters.
•Turn EDIT 1 (without pressing a button) (EDIT 1)
•Turn EDIT 1 while pressing TAP (EDIT 2)
•Turn EDIT 1 while pressing BYPASS (EDIT 3)
If the BYPASS LED is lit the effect is bypassed.If you want to adjust the noise
reduction sensitivity you can hold down the TAP button and turn the EDIT 1 knob
simultaneously.
NOTE:
You can’t adjust the effect parameters while the BYPASS LED is lit.
TAP (EDIT 2) and LED
This button enables you to set the speed of a modulation-type effect such as
CHORUS or FLANGER, or set DELAY times or REVERB lengths; simply press
the button twice at the desired interval.
The LED blinks at the specified speed or time.
HINT: To set the time to exactly match the tempo of a song, press the TAP button sev-
eral times along with the song.