Filter
Top Products
Problem
There is no power when the power switch is turned on.
The input source (i.e. disc player, karaoke machine) is
playing but there is no sound from the output source
(i.e. amp or mixer).
The LED display says “ERROR! FINALIZED DISC”.
The LED display says “ERROR! CDRW DISC ONLY”.
The final recording sounds too loud or distorted.
I am unable to record onto an 8cm CD-R/RW disc.
The CD-RW disc will not play in my CD player (Car audio,
home audio, etc.)
Solution
• Make sure the power cord is firmly connected to the
AC IN terminal on the back of the CDG-1000 PRO.
• Make sure the power cord is securely connected to the
power outlet or the surge protector/power strip.
• Make sure your surge protector/power strip is plugged
in and turned on.
• Press the record button to switch the CDG-1000 PRO
to recording mode. The input audio can only be heard
when the CDG-1000 PRO is in recording mode.
• Make sure the audio ins and outs are connected prop-
erly.
• If using the Analog RCA inputs be sure the CDR-1000
PRO is in ANALOG mode and if using the DIGITAL input
make sure it is in DIGITAL mode.
• If the disc is finalized, it cannot be recorded on. Put in
a blank or non-”Finalized” disc for recording.
• This happens if you try to ERASE a CD-R. The ERASE
function only works on CD-Rewritables (CD-RWs).
• The recording volume may have been set too high. Try
re-recording and adjust the recording volume so that the
bars on the Input Volume meter do not reach the orange
bars.
• Make sure you are connected to the Digital input. The
Analog input does not support 8cm discs.
• Most standard CD players (Car audio, home audio,
etc.) do not support CD-RW discs. If using CD-RW discs,
make sure that your CD player specifies that it is CD-RW
compatible.
Troubleshooting
12