Filter
Top Products
Vestax Corporation
SPECIFICATION
MOTOR
STARTING UP TIME
STARTING TORQUE
BRAKING SYSTEM
RAMBLE S/N RATIO
SPEED
PITCH
WOW & FLUTTER
TYPE
EFFECTIVE LENGTH
TRACKING ERROR
STYLUS PRESSURE
LIGHT OPTIONAL )
SPEED LOCK
REMOTE
DIMENSION
WEIGHT
POWER
TURNTABLE
ARM
DIRECT DRIVE QUARTZ
0.5sec 33 1/2 rpm 70
1.6kg cm
ELECTRONIC BRAKE
78dB IEC 98 WTD
33 1/2 rpm, 45rpm
10% DETOUCHABLE 100mm FADER
0.03% W.R.M.S.
ANTI SKIPPING TONE-ARM SYSTEM. TRACING
HOLD BALANCE SYSTEM
230mm 1mm
+2 32 +0 32
ADJUSTMENT RANGE 0 7.0g
DETOUCHABLE MINI LIGHT DC12volt 100mA
QUARTZ LOCK
MOMENTARY START MINI JACK
W 450mm X H 150mm X D 370mm
9.5kg
AC120V or 230V
REMOTE CONTROL
It is possible to control two turntables remotely.
1
Prepare for 3.5mm monaural phone plug cable Turn on Sync ON/OFF SW.
2
Connect REMOTE OUT JACK at the rear panel with another PDX-d3S REMOTE IN JACK at the rear panel
by using the cable.
3
The player connected at the REMOTE OUT JACK is MASTER of the PDX-d3S. The player connected at the
REMOTE IN JACK is the Slave of the PDX-d3S.
4
Pushing START/ STOP SWITCH of the master PDX-d3S will make the connection between master PDX-d3S
and slave PDX-d3S. Then slave PDX-d3S acts the same as master PDX-d3S without touching slave PDX-
d3S. Connecting the REMOTE IN JACK of third PDX-d3S with REMOTE OUT JACK of slave PDX-d3S, third
PDX-d3S will also act the same as master PDX-d3S It is possible to connect a fourth PDX-d3S, to be
controlled the same as master PDX-d3S by REMOTE CONTROL.
MASTER SLAVE1 SLAVE2
CONNECTION
ex.