Venturer ASR150 Home Theater System User Manual


 
2
CAUTION
The lightning flash with an arrowhead symbol,
within the equilateral triangle, is intended to alert
the user to the presence of uninsulated "danger-
ous voltage" within the product's enclosure that
may be of sufficient magnitude to cause an elec-
tric shock.
The exclamation point within the equilateral tri-
angle is intended to alert the user to the pres-
ence of important operating and maintenance
(servicing) instructions in this owner manual.
WARNING: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
The symbol for Class II
(Double lnsulation)
FCC Information
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesirable operation.
Notes on Placement
Do not use the unit in places which are extremely hot, cold, dusty, or humid.
Place the unit on a flat and even surface.
In a cabinet, allow about 2.5cm (1 inch) of free space around the unit for adequate ventilation.
Do not restrict the air flow of the unit by placing it in a place with poor air flow, by covering it with a cloth, or by
placing it on carpet.
Notes on Safety
When connecting or disconnecting the AC cord, grip the plug and not the cord itself. Pulling the cord may
damage it and create a hazard.
Unplug the unit during lightning storms or when unused for a long period of time.
Check that the rated voltage of your unit matches your local voltage before use.
No naked flame sources, such as lighted candles, should be placed on the apparatus.
Be sure to use it near the wall outlet. If a malfunction occurs, disconnect the plug from the wall outlet at once.
When the AC power supply cord is connected, the power indicator on the AC Adaptor will remain on although the
unit is turned off. Disconnect the AC power supply cord from the AC outlet when not in use.
Note on Condensation
When left in a heated room where is warm and damp, water droplets or condensation may form inside the unit.
When there is condensation inside, the unit may not function normally. Let the unit stand for 1 to 2 hours before
turning the power on, or gradually heat the room up and dry the unit before use.
Notes on Maintenance
Do not use volatile chemicals on this unit. Clean by lightly wiping with a soft cloth.
Do not place a heavy object on or step on the unit. The object may fall, causing serious personal injury and serious
damage to the unit.
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the
point where they exit from the unit.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO
NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
(FOR USA AND CANADA ONLY)
PRECAUTIONS
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING:
• Should any trouble occur, disconnect the AC power cord and refer servicing to a qualified technician.
• Do not place anything directly on top of the unit, it may cause damage.