Filter
Top Products
FRONT PANEL CONTROLS AND DISPLAYS
FRONT PANEL CONTROLS AND DISPLAYS
Figure 1: Front Panel Connections of the SC-602 amplifier.
Following are brief descriptions of the controls described in Figure 1. More detail on these
controls can be found in the next section.
(1) Power Switch
This button forces your SC-602 amplifier into standby mode. The power LED turns amber,
the numeric LED shuts off, and the amplifier puts out no power. The unit will remain in this
mode until the POWER button is pr
essed again. To fully deactivate (i.e. power down) the unit,
use the main power switch on the back panel.
(2) Power LED
This LED illuminates when the power is on. Blue is normal operation. It tur
ns amber when
the unit is in standby mode or the remote has been used to deactivate the unit, and dims
when the unit is in night mode.
(3)
Mic Input
Connect the supplied microphone for the Auto-EQ feature to this mini-jack input.
(4)
Remote Eye
This is the eye that receives infrared commands from the supplied remote control.
(5) Crossover
Use the UP and DOWN buttons to select the low-pass crossover frequency. All information
above this frequency is reproduced by your speakers. Information below this frequency is
handled by your subwoofer
. The fr
equency is briefly indicated on the LED display
, then the
display reverts to showing the subwoofer’s volume level. The slope is fixed at 24 dB/octave.
T
o deactivate the cr
ossover, press the up crossover button until two dashes on the display
indicate the crossover is deactivated and the woofer plays all frequencies presented to it.
Please see page 9 for a more detailed discussion on crossovers.
Installation
3
.
www.velodyne.com
SC-602 Amplifier User’s Manual
602