Filter
Top Products
2
.
www.velodyne.com
SC-602 Amplifier User’s Manual
SC-600 IW, SC-600 IF/IC SUBWOOFERS
SC-600 IW (In-Wall):
- Two high excursion 6.5” active drivers, two 12.5” x 3” oval
passive radiators with ribbed rubber surround
- High-excursion rubber surround
- 2” dual layer voice coil
- Frequency Response: 37 - 120 Hz (+/- 3 dB)
- 4 ohm impedance
SC-600 IF/IC (In-Floor/In-Ceiling):
- 12” (9.7” piston diameter) subwoofer
- 2.5” dual layer voice coil
- Oversized spider for linearity at high excursion
- High-excursion rubber surround
- Frequency Response: 25 - 120 Hz (+/- 3 dB)
- 4 ohm impedance
Be sure to do the following to ensure the best performance from your subwoofer:
❑ If possible, optimize the placement of the subwoofer(s) in the listening area.
See page 10 of the User’s Manual.
❑ Install and wire the subwoofer per the instructions on pages 3 - 8.
❑ Set the amp to the proper subwoofer model per the instructions on page 11.
❑ Select the proper volume level. See page 4.
❑ Select the pr
oper low-pass cr
ossover frequency. See pages 9 - 10.
❑ Equalize the subwoofer using the microphone and Auto-EQ feature. See page 12.
❑ Adjust the phase contr
ol on the remote to the correct setting. See page 12.
❑ Select the cor
rect preset for the source material. See page 13 - 14.
Your new Velodyne amplifier provides for a number of installation options. Read all the
installation information below in order to determine which installation option is best for your
system. Remember to per
for
m all installation pr
ocedur
es with system power tur
ned of
f.
Setup Checklist