Filter
Top Products
T
his section addresses day-to-day usage of your SC-602 amplifier.
Remote Control
The features of the SC-602 remote control are listed below.
• POWER — This button forces your SC-602 amplifier unit into
standby mode. The power LED turns amber, the numeric LED
shuts off, and the amplifier puts out no power. The unit will
remain in this mode until the POWER button is pressed again.
To fully deactivate (i.e. power down) the unit, use the main
power switch on the back panel.
Note: The master power switch on the rear panel must be on
in order for the front power button to function.
• MUTE — This button mutes the subwoofer’s output. The LED
on the amplifier will show 00 if the unit is muted. To unmute
the subwoofer, press the MUTE button again and the original
volume setting shows on the LED.
• EQ — This button automatically equalizes the subwoofer’s frequency response using a 5-band
internal graphic equalizer. Prior to engaging this feature, hook up either one or two SC-600
subwoofers to the SC-602 amplifier
. To use this feature, first plug the supplied microphone
into the Mic-In jack on the fr
ont panel of the amplifier and place the mic in your preferred
listening position. Then press EQ on the remote for about 2-3 seconds. The subwoofer(s)
emits 12 “sweep tones” that cover the frequencies between 20 and 150 Hz. The LED
displays “AU” during the Auto-EQ process. After the sweeps are complete, the unit saves its
EQ settings and r
eturns to normal operation. To prevent accidental invocation of the EQ
feature, you must hold down the EQ button for 2-3 seconds before the EQ sweeps begin.
Note: Each time the EQ feature is utilized, the EQ settings for the SC-602 amplifier are reset.
If the microphone is not plugged in, the SC-602 amplifier will emit one or two sweep tones then
cease the EQ operation. In this case, the pr
evious EQ settings will be pr
eserved.
• PHASE — These buttons allow you to optimize the subwoofer performance for the location
and your listening position. Play some bass heavy music. While listening, push one of the four
phase buttons, listen for a few moments, and then press the next phase button. In most
installations, one of the four button positions will offer an audibly better blend of subwoofer
and speakers. Selecting the cor
r
ect phase position is that easy
. The LED will show the phase
selected by showing “PH” followed by the phase number: 0, 90, 180 or 270.
•
LIGHT —
If you wish, you can deactivate the numeric LED on your SC-602 amplifier
. To
do this, press the LIGHT button on your remote. To reactivate the LED, press the LIGHT
button again.
• NIGHT — Night mode limits the maximum output of the subwoofer for late night listening
or to be more considerate of close neighbors. Press the night button to turn the night
mode feature on or off. Night mode, when active, will reduce the brightness of the blue
power LED.
12
.
www.velodyne.com
SC-602 Amplifier User’s Manual
Usage
Figure 4: SC-602 Remote.