Filter
Top Products
ADDITIONAL INFORMATION[ 38 ]
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and
the base unit. Normally, setting the code is not necessary.
The first time you charge your handset, the security code is automatically set.
(See "About the digital security code", page 6.)
In the rare situation that you suspect another cordless telephone is using the same
security code, you can change the code.
1) Remove the handset from the base unit. Press and hold find handset on the base.
2) The handset begins emitting a paging sound. While holding find handset, place
the handset in the base unit. The paging sound stops.
Leave the handset in the base for more than 3 seconds. A new random security
code is set.
Installing the Beltclip
To attach the beltclip
Insert the beltclip into the holes on each side of the handset. Press down until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs from the holes.
Headset Installation
Your phone may be used with a genuine Uniden accessory headset
(model HS910).
To use this feature, insert headset plug into the headset jack.
Your phone is ready for hands-free conversations.
(Headset may be purchased by calling the Uniden Parts Department or
visiting the web site at www.uniden.com)
If the handset battery
pack is completely
discharged or the
battery pack is removed,
the digital security code
will be lost. If this
happens, a new security
code is set
automatically next
time the battery pack
is charged.
EXT176 7/30/2 11:10 AM Page 38