Uniden EXT 176 Headphones User Manual


 
GETTING STARTED
GETTING STARTED [ 13]
Direct wall mounting
If you don't have a standard wall plate, you can mount your phone directly to the
wall. Before doing this, consider the following:
Avoid electrical cables, pipes, or other items behind the mounting location that
could cause a hazard when inserting screws into the wall.
Try to mount your phone within 5 feet of a working phone jack to avoid excessive
lengths.
Make sure the wall material is capable of supporting the weight of the base
and handset.
Use #10 screws (minimum length of 1-3/8 inches) with anchoring devices suitable
for the wall material where the base unit will be placed.
1) Insert two mounting screws into the wall, (with their
appropriate anchoring device), 3-15/16 inches apart. Allow
about 1/8 of an inch between the wall and screw heads for
mounting the phone.
2) Refer to steps 1 through 6 on pages 12 to mount the telephone.
Terminology
Throughout this manual, terms such as Standby and Talk Mode are used. Below is the
terminology explanation.
Standby Mode - The handset is not in use, off the base, and talk/flash has not
been pressed. A dial tone is not present.
Talk Mode - The handset is off the base and talk/flash has been pressed enabling
a dial tone.
EXT176 7/30/2 11:10 AM Page 13