USING THE SPEED DIAL MEMORY [22]
www.uniden.com
5) Store Number is displayed. The cursor flashes indicating that the
display is ready for the number to be entered.
6) Use the keypad to enter the phone number; each number can be
up to 20 digits.
If you need the phone to pause during the dialing sequence, press
the redial/pause key to insert a two-second delay between the
numbers. You can enter multiple pauses to increase the delay.
Each pause counts as a digit. The display shows a
P
for every
pause.
When storing numbers into memory, if the handset is idle (i.e., no key is pressed) for more
than 30 seconds, it will beep rapidly, and the phone will return to standby mode.
7) Press the memory key. You will hear a confirmation tone, and the
following screen appears.
Memory storage is complete.
After about 2 seconds, the following screen displays all the speed
dial memory entries.
8) Press the end key to exit memory setup mode. The phone returns
to standby.
USING THE SPEED
DIAL MEMORY
USING THE SPEED DIAL MEMORY
EXAI7248.book 22 ページ 2004年1月15日 木曜日 午前11時56分