Filter
Top Products
user manual
QLight™ DP series
QLight DP series manual
page 21
MOUNTING AND FIXING
Rigging Hardware
A versatile range of mounting hardware is available that allows enclosures to be used in a variety
of ways, in either mobile applications or permanent installations.
A top hat stand type fitting is mounted in the base of
QLight™ series cabinets for use with 35mm diameter
loudspeaker stands with a load rating of at least 37kgs
(82lbs).
Pole mount sockets are also fitted to the top of QLight™
series subwoofers. This allows these two enclosures to be
used together as an extended frequency range system as
shown with the TQ-445DP mounted above the TQ-425DP.
An optional 35mm diameter straight pole used between
these enclosures enables a minimum footprint and ensures
the correct vertical distance between cabinets.
Internal metric threaded rigging points are provided
on the TQ-445DP cabinet enabling it to be flown using
optional M10 shoulder eyebolts. Downward
inclination of the enclosure can be adjusted using an
additional rigging point on the rear of the cabinet.
Note: these rigging points must NOT be used to rig a
second enclosure in a vertical column.
Side-mounted flying strips can be fitted to the sides
of the TQ-445DP enclosure by removing the
countersunk bolts on the top and sides of the cabinet
and replacing them with the M10 bolts supplied with
the hardware. Two flying strips are required for each
enclosure; one attached to each side. This method
offers a simple and cost effective method of flying
single enclosures in permanent installations.
Enclosures may be arranged in a vertical column by
coupling the flying strips together using QL-75