Filter
Top Products
1-89
OPERATION
Troubleshooting (Continued)
Symptom
Some channels are
skipped over when
using CH/TRK (+/-)
Picture and sound of
broadcasting channel
are weak or missing.
Camcorder image is not
shown.
Camcorder image via
A/V input to DVD+VCR
is not shown on TV
screen.
Timer recording is not
possible.
TIMER indicator
appears after DVD+VCR
is turned off.
Stereo Audio Record
and/or Playback is not
present.
Cause
z Those channels were deleted with the
CH. ADD/DEL option.
z Antenna or cables are loose.
z Wrong TUNING BAND option is being
used.
z Camcorder is off.
z DVD+VCR SOURCE SELECT is not set
to LINE1 or LINE2.
z Clock in DVD+VCR is not set to correct
time.
z Timer has been programmed
incorrectly.
z TIMER indicator does not appear after
programming timer.
z DVD+VCR is in Timer Recording mode.
z TV is not Stereo-compatible.
z Broadcast program is not in stereo for-
mat.
z DVD+VCR A/V Out jacks are not con-
nected to TV A/V In jacks.
z DVD+VCR Audio/Video Out is not
selected for viewing at the TV.
z DVD+VCR BROADCAST TYPE mode is
set to SAP or MONO.
Correction
z Use CH. ADD/DEL. to restore channels.
See “Channel Selection” on page 16.
z Tighten connections or replace cable.
z Try all TUNING BAND options. See
“Channel Selection” on page 16 for
details.
z Turn camcorder on and operate
properly.
z Press INPUT SELECT to select LINE
input channel (LINE1 or LINE2).
z Set clock to correct time. See “Setting
the Clock” on page 17.
z Reprogram Timer. See “Timer
Recording” on page 24.
z Reprogram Timer
z This is the normal indication that the
DVD+VCR is in TIMER mode.
z No action is possible.
z No action is possible.
z Make A/V connections. Stereo is
available only via A/V output from
DVD+VCR.
z Select AUX or A/V source as TV input.
z Set BROADCAST TYPE mode to
STEREO. See “Setting the VCR Setup
Menu” on page 16.
Moisture Condensation
Moisture condensation can occur:
• When the DVD+VCR is moved from a cold place to a
warm place.
• Under extremely humid conditions.
In locations where moisture condensation may occur:
•
Keep the DVD+VCR plugged into an AC power outlet
with POWER On. This will help prevent condensation.
• When condensation has occurred, wait a few hours
for the DVD+VCR to dry before using it.